Carnegie Robotics 55001384 Autonomy Controller Module

规格

• 制造商： 卡内基机器人公司
• 型号： 55001384
• 整合说明： KDB 996369 D03 OEMManual v01

描述

Qualcomm® Robotics RB5 Core Kit consisting of Thundercomm TurboX C865 System on Module with customization around 12GB Ram and external antennas enabled for system integration. See Qualcomm or Thundercomm hardware manuals for specifications to each product.

Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01 (ISED recognized)

适用的 FCC 规则列表

1. CFR 47 FCC PART 15 SUBPART C&E has been investigated. It is applicable to the modular. Specifically, an assessment of the worst case operating conditions has to be performed by the module integrator and tested on the host product for compliance to FCC part 15.247 and part 15.407.

具体操作使用条件

1. 此模块为独立模块，若终端产品涉及主机内多台同时发射或不同独立模块发射机运作情形，主机厂需与模块厂协商在终端系统中的安装方式。
2. Limited module procedures. – Not applicable
3. Trace antenna designs. – Not applicable

射频暴露注意事项

1. To maintain compliance with FCC’s and ISED’s RF Exposure guidelines, this equipment should be installed and operated at a minimum distance of 20cm from your body.

天线

1.  This radio transmitter FCC ID: 2AMDR-55001384 / IC: 24410-55001384 has been approved by the Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.

内部的 鉴别	天线说明	天线类型	最大天线增益
Antenna 0**	无线天线	External Antenna 2X MIMO WIFI	2.4G Wi-Fi: 1.2 dBi, 5G Wi-Fi: 2.0dBi
天线 1	无线天线	External Antenna 2X MIMO WIFI	2.4G Wi-Fi: 1.2 dBi, 5G Wi-Fi: 2.0dBi

• Bluetooth has been disabled on device and has not been tested

Antennas Tested

• Abracon Part Number AECW0401W2-0600F_DS
• Taoglas MA210.K.CG.001

Label and compliance information.

1. The final end product must be labeled in a visible area with the following: Contains FCC ID: 2AMDR-55001384, IC: 24410-55001384

有关测试模式和其他测试要求的信息

1. The Host manufacturers are strongly recommended to confirm compliance with FCC and ISED requirements for the transmitter when the module is installed in the host.  Additional testing, Part 15 Subpart B and ICES-003 disclaimer The host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for the system such as FCC Part 15 B and ICES-003.

FCC 警告

• 任何未经合规负责方明确批准的更改或修改都可能使用户操作该设备的权限失效。

FCC and ISED Statements

This device complies with Part 15 of the FCC Rules and with ICES-003 of the ISED rules. Operation is subject to the following two conditions:

1. 本设备不得造成有害干扰，并且
2. 本设备必须接受任何收到的干扰，包括可能导致不良操作的干扰。

重要提示：
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of the ISED Canada rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• 重新调整或重新定位接收天线。
• 增加设备与接收器之间的距离。
• 将设备连接到与接收器不同电路的插座上。
• 请咨询经销商或经验丰富的无线电/电视技术人员寻求帮助。

Statements regarding human exposure

• With respect to radiofrequency radiation exposure Information, it is declared that this equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment.
  • This equipment should be installed and operated at a minimum distance of 20 cm between the radiator and your body.
  • 此发射器不得与任何其他天线或发射器共置或配合操作。

常见问题解答

What are the recommended distances for RF exposure compliance?

The equipment should be installed and operated at a minimum distance of 20cm from the body to comply with FCC's and ISED's RF Exposure guidelines.

Can I use antennas not listed in the manual?

Antenna types not included in the approved list are strictly prohibited for use with this device to maintain compliance.

文件/资源

Carnegie Robotics 55001384 Autonomy Controller Module [pdf] 使用说明书 55001384, 2AMDR-55001384, 2AMDR55001384, 55001384 Autonomy Controller Module, 55001384, Autonomy Controller Module, Controller Module, Module

参考

• 用户手册